Royce,
Remove the left side panel, and you should see a 5.6k resistor soldered
between pin 6 and pin 1 of the microphone jack. Lift the resistor from
pin 1 and an non-amplified Kenwood microphone should work just fine.
If it is an amplified mic, you will have to remove the front panel and
chenge the microphone configuration header to route +5 volts to pin 5
instead of pin 6.
73,
Don W3FPR
On 9/11/2013 8:09 PM, ROYCE RAINWATER wrote:
I have purchased a used k2 which has the ksb2 ssb adapter installed and was
used with the elecraft hm 2 which I did not get. I have a kenwood hand
mike that came with the kenwood ts590 and am looking for advise configuring
the k2 for the kenwood hand mike.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
