Correct.
Refer to the K3 manual, page 56, KXV3: "If KXV3 is set to TEST, the
K3 will use low power (0.1 to1.50 mw) on all bands, including hte HF
and transverter bands. RF input/output is via teh XVTR IN/OUT jacks
in this case. To access the TEST setting, KXV3 must first be set to
NOR, then K3 turned off/on.
The K3 will transmit on any frequency from 490-KHz to 30-MHz in the
test mode if you have the General Coverage filter installed.
This procedure is how I used the K3 to transmit on 495-510 KHz under
the experimental license WD2XSH/45. I found I only need 0.1 mw to
drive my NDB transmitter. I insert the K3 drive in place of the
standard xtal oscillator. Details of this is on my 600m webpage.
73, Ed
------------------
Subject: Re: [Elecraft] [600MRG] Use of K3 on 600m (and below)
Message-ID: <[email protected]>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed
Fred,
I believe Ed is referring to the KXV3 TEST mode. See page 50 of the
manual, the first bullet in the Milliwat TX Gain Calibration.
That is different than TX TEST.
73,
Don W3FPR
73, Ed - KL7UW
http://www.kl7uw.com
[email protected]
"Kits made by KL7UW"
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
