Hi Steve, What firmware rev are you using?
If you're using 1.57 or later, the release note info below applies. You can use the procedure to clear the ATU TUNE settings for the band you're on (see below). Release notes are always available with new firmware. I believe your KX3 resets its power to 5W because of high SWR caused by one or more bad ATU settings that are due to you tuning into that high SWR load. The ATU will use the memorized settting that is nearest in frequency to one you've already tuned. Anyway, you can try this and no damage will come from it. Quote Note: If you switch to a different antenna, such as when taking the KX3 into the field, you may want to clear old ATU LC settings for one or more bands prior to doing new auto-tunes. To do this, locate the ATU MD menu entry, then hold CLR (hold function of the OFS/B knob). You can change bands from within this menu entry using BAND +/-. Unquote 73, matt W6NIA On Sat, 21 Sep 2013 09:22:39 -0400, you wrote: >I accidentally tuned my KX3 into a high SWR output on 20m. Now it won't >transmit into a low SWR output on 20 at over 5 W. When I set it to 10 W, resets itself to five. Other bands are fine. This smells like something in firmware. Is there anywhere to clear it? > >Thanks and 73, Steve. Matt Zilmer, W6NIA www.elecraft.com 831-763-4211 x129 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
