Thank you I will check... Scotty/NU0S
Sent from my Verizon Wireless 4G LTE DROID Don Wilhelm <[email protected]> wrote: Scotty, The most common cause for that behavior is a problem with T1 - leads not adequately stripped and tinned, leads not in the correct holes, the toroid wound in the wrong direction (it must be *exactly* like the figure in the manual), inadequate soldering. One other (but less common) cause is for there to be a capacitor or inductor that is being left in the circuit. The normal cause of that is missing a solder connection to one of the relays or the firmware IC. 73, Don W3FPR On 10/5/2013 6:10 PM, Scotty Long wrote: > Just installed NB works great. > > Newly installed KAT1 page 9 no appreciable value change volts when adjusting > C9... > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
