I have a K2/KAT2 and a homebrew Buddistick.
I'm trying to tune the antenna for best resonance on 30m (10.125mhz)
without the KAT2 in the circuit to ensure optimal power out.
The antenna is build according to plan with the correct whip, coil and
counterpoise (radial)
Here's my problem.
Following the KAT2 manual "bypassing the matching network...", and using
the suggested alternative procedure, ie. go to menu and set ATU AUTO and
using dummy load DL1, tune the frequency.
I then go to menu and set ATU 1.0-1, back out of menu, switch to
antenna, hold TUNE and read the SWR.
The SWR is 9.9:1, no matter how I shorten or lengthen the radial or the
whip.
Obviously, I must be doing something wrong.
Ok, back to the manual...I'll try CALS.
Again I load up the dummy using AUTO to cancel stray inductance and
capacitance, go to menu, set ATU CALS, backout of menu, switch to
antenna, hold TUNE.
Initial SWR is now 4.3:1...I seem to be on to something. I adjust the
radial length back and forth and achieve 1.2:1 with power set at 2W, I
read 2.3F 0.0R.
This looks too good to be true....
Is the ATU providing the match or am I?
I don't have access to an antenna tuner.
Can anyone clarify the correct procedure, given that the first
recommended method didn't work but the second seems to have?
73, Bryan VE6HBS
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
