Paul: Assuming that you are using the Elecraft cables - the mic audio and PTT from the front panel Mic connector of the K3/0 is hard wired to the Mic mono and PTT In on the rear panel of the K3/0. The Elecraft cable then takes those signals to the AUX/MIC RJ-45 connector on the front panel of the Control RRC (refer to Fig 10, pg 13, K3 Remote Users Manual. Once the K3/0 and the K3/100 are talking any setting on the K3/100 is reflected on the K3/0 (don't make the mistake of thinking that the K3/0 can be set differently from the K3/100). So you need to set the K3/0 Mic (which is really controlling the K3/100) to be rPL.
Good Luck Doug VE3MV On 2013-Oct-13, at 10:26 AM, "Paul A DeFelice" <[email protected]> wrote: > Just received my K3/0 and in the process of setting it up. RX, dual RX and > CW are working great. I can't get any audio on SSB. I have the remote > (K3/100) MIC SEL set to rP.L and the local K3/0 MIC SET set to fP.L . The > mic plugged into the front connector of the K3/0. PTT is working but no ALC > defection. Any suggestions? > > > > 73, > > Paul K9NU > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
