Julie,
The KX3 power in CW and data modes is *not* limited to 5 watts (except
when running it on internal batteries).
I believe the solution to your problem can be found in the TUN PWR menu
parameter - see page 40 of the manual. The power level set there will
be transmitted when you do a TUNE (not an ATU TUNE). Yours is most
likely set to NOR for which the TUNE power is the same as the power knob.
TUNE will send a carrier (CW) no matter what mode the KX3 is set to.
73,
Don W3FPR
On 10/13/2013 1:01 PM, Julie Royster wrote:
The LDG tech support folks say that a 5-watt KX3 output is not enough to
trigger tuning by their product.
We will eventually have the Elecraft tuner for KX3 when it ships, but for
now what selection of modes & power etc on KX3 would give me the
highest-wattage signal for the autotuner? If I understand it correctly, PSK
and CW are limited to 5 watts by the KX3, right?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
