-------- Original Message --------
Subject: [KX3] Re: KX3 2-meter module progress report
Date: Wed, 16 Oct 2013 11:20:44 -0700
From: Wayne Burdick <[email protected]>
David Anderson <[email protected]> wrote:
> What is the planned receive frequency coverage of the 2m module?
144-148 MHz, minimum, for full sensitivity. However, we allow tuning well above
and below this range (at least 20 MHz), even though sensitivity gradually falls
off. For example, this allows copy of weather-band stations at 162 MHz which are
generally very strong, at least at my QTH near San Francisco.
> Is there any 144-146 band pass filter to limit strong out of band signals
from pagers and other fixed services outside the band?
> I have in the past studied our RF environment on the band.
http://www.gm4jjj.co.uk/preamp/index.html
Filtering is included at all stages of the receive path, including a 10-element
band-pass filter ahead of the mixer. But because the module is so small, there's
no room for a high-Q, tuned band-pass filter at the input; instead, we use
low-loss low- and high-pass filters to preserve sensitivity. To reduce the need
for narrow input filtering, we used a high-intercept LNA that is likely to do OK
in all but the very worst RF environments. This increases current drain of the
radio on 2 meters somewhat compared to other bands, but we felt it was an
acceptable tradeoff.
Since the KX3-2M module has its own antenna jack, you could use an external
high-performance 144-148 BPF if required. It isn't clear from your sweeps (the
URL above) whether this would be necessary for your use of the module, though it
certainly wouldn't hurt.
> Is the frequency stability basically the same as that of the KX3?
HF/6-m and 2-m stability are correlated since they're referenced to the same LO.
For CW/SSB, we strongly recommend performing the KX3's extended VFO temperature
compensation procedure, providing typical stability of +/- 2 to 3 Hz on 6 meters
and +/- 5 to 10 Hz on 2 meters. The standard compensation (done at the factory)
yields greater variance, but is entirely sufficient for FM or AM operation. We
hope to simplify the extended compensation procedure in conjunction with the
KX2-2M product release.
In both transmit and receive mode, the operating frequency is subject to small
asynchronous corrections arising from temperature changes. On 6 meters and lower
these corrections have a granularity of 1 Hz. On 2 meters they're about 3 Hz due
to the conversion scheme used. We're looking into improving the granularity on 2
meters, but the overall range of corrections--about +/- 5 to 10 Hz--is about as
good as it gets on this band with a conventional temperature-sense IC.)
> You will have gathered that my interest is weak signal work on 144 and as an
IF for microwave transporters.
What modes do you plan to use?
73,
Wayne
N6KR
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
