I am having a configuration issue that I have spent hours trying to figure out and need some help please.
As a CW person, I seldom operate SSB but I am trying to get set up for this weekend's CQWW SSB contest. I have tried posting two configuration pages from K3-EZ but with the file size limitation of about 30 kb and I exceed that. Below are some of my configuration for my K3. In any band in the SSB portion, I have no audio output anytime I am in the USB or LSB mode, however if I change from USB/LSB to CW, I have normal audio but of course I can't copy the SSB signals. This is true whether I have my SUB rx turned on or not. I have my CM-500 headset plugged into the rear of the K3 and I have RadioSport RS20S headset plugged into the front panel PHONES jack and I have no audio in the SSB mode with either or both of the headsets plugged in. With both headsets removed, I have no speaker audio in USB or LSB mode, but normal audio in the CW or AM mode. In CONFIG I have: SPKRS = 1 SPKR + PH =YES L-MIX-R = A b I am pretty sure I have one configuration set incorrect, but using both the Elecraft K3 Owner's Manual and Fred's 'The Elecraft K3' manual, so far I cannot find what I have incorrect. Any helpful suggestions would be greatly appreciated. 73, Tom - W4BQF ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
