Minor corrections to the entered values.
From: Tommy [mailto:alderm...@windstream.net] Sent: Friday, October 25, 2013 10:39 PM To: Elecraft@mailman.qth.net Cc: alderm...@windstream.net Subject: Re: K3 SSB got lost = Solution Again thanks to all who actually read my post and offered helpful suggestions. I have finally discovered the infamous operator error that caused my K3 to lose rcvr audio when I would change modes from CW to SSB. As mentioned in my original post, for the past 61 years I have been primarily a CW operator, therefore seldom paid close (enough) attention to the settings for the voice modes. Therefore when setting up the Rx Equalization, I set it up for CW with the below setting: 50 100 200 400 800 1600 2400 3200 -16 -6 +15 +16 0 [CTA] -15 -16 -16 AND I did not set up Rx Equalization for USB/LSB. I did save the configuration for CW. Obviously when I switched to USB or LSB, I could hear no voice audio. It was only after discovering my 'operator error' I changed USB/LSB to: -16 -16 -16 +8 +12 +12 [CTA] +12 -16 And now I have normal audio (to my ears) in all three modes. Thanks again for your helpful suggestions and let's close this thread. 73, Tom - W4BQF [CTA] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
