Fred,
If it is "off frequency", then moving the VFO one way or another should
bring the decoded signal so it sounds normal.
So I doubt it is really "off frequency" because you said it gets worse
either way you move the VFO.
I would suggest that you be certain the NR and NB are off and try again.
Where do you have the filter width set and where is it centered? The low
end should be at 300 Hz or a bit below that, and the high end should be
2400 Hz or greater.
73,
Don W3FPR
On 10/27/2013 2:31 PM, Fred Smith wrote:
I just received my second KX3 and it seems to have an issue. On LSB "only"
it sounds like its off frequency when it shows dead on where it should be.
Tuning up or down makes it over more so, if you listen closely it seems to
be on but garbled. Never had this happen on my first KX3 on LSB and on this
one all other voice modes USB and AM are fine.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html