John,
You cannot configure Winwarbler to use the same Com port as Commander,
but you can configure WinWarbler to send requests to Commander to use
radio control commands for CW keying with a K3 or KX3. In the WinWarbler
Configuration window under the CW tab, set the Keying method to Xcvr
Ctrl App (lower left corner).
If you want to use a K1EL Winkeyer or direct serial port keying (DTR or
RTS), you have to use a separate Com port.
73,
Rich VE3KI
W9LHG wrote:
I'm trying to send CW from DXLabs to the KX3 with
WinWarbler. At the same time, I'm also running
Commander and DXKeeper.
Commander controls the KX3 fine, and WW outputs CW
but the KX3 doesn't recognize it. I had hoped that
the same Com port 5 could be used for both.
Anyone make that work, or are two Com ports required?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
