In my view the manual is not wrong in that respect. It tells you to set the
TUN PWR menu item to NOR before you start.
However, I have always found a different problem. The last step of the
procedure tells you to hold TUNE and adjust the menu parameter (WMTR: LP or
HP) for exactly 5w or 50w. But holding TUNE takes you out of the menu. So I
adjust the menu parameter when the K3 is not txing and then hold TUNE again
to see what the effect has been, repeating the process as necessary to
achieve 5w or 50w. Anyone else see this? Or have I been doing it wrong these
last 5 (nearly 6) years (quite possible hi).
73 to all
Geoff
G3UCK
-----Original Message-----
From: Roger D Johnson
Sent: Thursday, October 31, 2013 3:05 PM
To: [email protected]
Subject: [Elecraft] Wattmeter Calibration
I finally figured out what was happening. The procedure in the manual is
wrong!
On step 5, the power is set by the FRONT PANEL POWER CONTROL
On step 7, TAP tune, do NOT hold it. If you hold it, you get the tune power
which
is a separate menu item.
To key the tx in CW I had to insert a shorted plug in the key jack on the
rear
panel.
The WMTR LP menu item is evidently controlled by the circuitry that switches
the
100 watt PA in and out. If the power control is set above a certain level,
the menu
item switches to WMTR HP.
73, Roger
--
Remember the Liberty (AGTR-5)
http://www.usslibertyveterans.org/
http://www.gtr5.com/
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
