Is it possible that your antenna is tuned already? If it weren't, and
the SWR were too high, you would not get 500 watts out of the amp. You
would get a FAULT message and the whole thing would shut down.
Buck
k4ia
On 11/12/2013 2:40 PM, Jim Bennett wrote:
Folks, sorry if this has been discussed on the reflector before, but I've
looked through the archives and drew a blank. I know I saw it but try as I may,
can't find any related posts.
I just this week added a KPA500 and KAT500 to my K3 station. Documentation sez that
the KAT500 tunes best when the K3 is set to 25 watts of tune power. OK, got that
set. But, what ideally should happen is that if the amp is in OPER mode and I press
& hold the TUNE button on the K3, the amp should temporarily go to STBY mode
until the tuner has finished doing it's thing. It doesn't - the amp fires out 450 -
500 watts - not cool.
Have I missed a setting somewhere that will make this happen, in case I forget
to put the amp in standby mode, before I run a tune cycle?
Tnx, Jim / W6JHB
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
