John,
That is just fine. I know a range was specified, but you are only 6%
out of that range and normally a 10% variation is acceptable.
In the case of those particular signals, they are connected only to the
P3 connector at this time, so your ohmmeter is reading only the
resistance displayed by U6 itself, and the actual reading is dependent
on which particular ohmmeter is being used.
73,
Don W3FPR
On 11/25/2013 2:28 PM, wt5y wrote:
K2 control board all resistance readings ok cept I get 95 k for U6 pins 29 30
which call for 70-90k.
WT5Y
Sent from my Cricket smartphone
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
