To simply test SCAN do the following: first push A>B then turn VFOB (small knob) clockwise a few turns then push SCAN
It should start scanning. The M>V REQ "error" message when you push SCAN is an indication that the higher freq is in VFOA and the lower freq is in VFOB. Even though you said you have it set correctly I would double check: If you want to scan, the top frequency in the display window should be the lesser frequency. 73, Drew AF2Z On Mon, 02 Dec 2013 12:39:09 -0800 (PST), you wrote: >I cannot get the K3 scanning function >to work properly. I am following the instructions in the K3 manual pg 40 >as well as the Fred Cady book pg. 46. I have used both the Elecraft K3 Memory >Editor >and entered the memories manually, to save the frequencies into the K3 >memories. When I press M>V, the freqs stored in memory are only being >recalled to VFO A but not to VFO B. So when I press Scan, no scan commences. If >I program the desired freqs into VFO A & VFO B manually, and then press >Scan, I get M>V REQ in the display window and no scan start. I have put the >lower start freq >in VFO A and the Stop in VFO B. I have also saved the desired mode with each >memory pair. > > >So obviously I am missing something in >this process but its not apparent to me in the manual nor could I find in the >archives. So what am I missing? > > >73 Paul >kc2nyu ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
