I bought the K2 (SN 4913) assembled. I don't see any special notes in the T4 section of the manual, but I'll check later today when the K2 is disassembled.
On-the-air checks with K3CC and VE3FMC show that the signal is good at 10W (KPA not active) and poor at 11 W (KPA on). SSB operation AT THE SAME GAIN SETTINGS is fine. ??? Would an impedance mismatch between the K2 and the KPA (when on) change the ALC response? ??? Thanks, Chris NQ8Z -- View this message in context: http://elecraft.365791.n2.nabble.com/K2-KPA-ALC-problem-tp7581353p7581400.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
