Ray, It fits neatly between the RX in and out BNCs on the back panel. You then select the separate receiver input via the RXant button of the front panel. I am away from the K3 at the moment but that is what I did successfully with an ANC noise reducer once. I too am thinking seriously about buying the PR6-10 as I'm about to take deliver of a KPA500!
73 Stephen G4SJP On 10 December 2013 09:20, Ray G3XLG <[email protected]> wrote: > Hi All > I am thinking of buying this accessory but I am a bit confused.....! > I use a 4-El SteppIR beam for the HF bands as both my receive & transmit > antenna with my K3. > Would I need to set up a separate receive antenna to use the PR6-10 Preamp > or can I use it with my existing TX/RX antenna? > > Ray G3XLG > > > > ----- > Ray G3XLG > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/PR6-10-Receiver-Pre-Amplifier-tp7581571.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
