Bruce,
The base K2 power is proportional to the power out of the KPA100 - so if
the KPA100 is running at 20 watts, the base K2 is driving at about 2 watts.
You can run 100% duty cycle transmissions safely at 35 watts, and could
probably push it to 50 watts if you provide auxiliary cooling for the
KPA100 and the receive periods are long enough to allow the heatsink to
cool. You could increase the cooling by placing a muffin fan over the
heat sink.
It is heat that will create problems - you can always use your fingers
as an indicator. If the surface of the heat sink is too hot to hold
your fingers on it, it is likely too hot. Don't forget that the base K2
PA transistors are on the bottom rear.
73,
Don W3FPR
On 12/26/2013 12:06 PM, K1FFX wrote:
I starting to use my K2/100 in two 100% key-down modes, JT-65 and PSK-31.
What
should I be keeping in mind in protecting the output stage for the K2 and
for the KPA100?
For JT-65, since it is a QRP mode, I'm running at about 5 watts, and
transmissions are
limited to about 45 seconds. So, I'm hoping that K2's output transistors
will not be stressed
in this mode.
But, how about PSK-31? I'd like to run about 20 watts and each transmission
could easily
be 3 or so minutes. I don't know at what output power the base K2 runs when
the KPA100
kicks in (i.e., at above 10 watts). I assume that normally the KPA100 will
be loafing at 20
watts, but I'm not sure the impact of 100% key down on its output stage.
I'd appreciate any guidance in keeping the K2/100 "safe" in these modes.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
