Ken, You have the SWT19 and SWT27 in the wrong macros, causing the reassignment to fail. Macro 1 assigns macro 1 to PF1 and macro 2 assigns macro 2 to PF1 rather than alternating so you get the desired toggling. Also, I always end with the mn255. Try these:
1 ---- BW0280;SWH12;MN110;SWT27;SWH18;MN255; 2 ---- BW0005;SWT12;MN110;SWT19;SWH18;MN255; 73, Jim -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Kenneth A. Christiansen Sent: Friday, December 27, 2013 5:19 AM To: [email protected] Subject: [Elecraft] Toggle PF1 in KX3 Hi from Ken W0CZ I want to toggle between BW 2800 and BW 50 on my KX3. I wrote the following macro lines and they work from the command line of the utility but do not toggle when using the PF1 of the KX3. 1 ---- BW0280;SWH12;MN110;SWT19;SWH18;SWH09; 2 ---- BW0005;SWT12;MN110;SWT27;SWH18;SWH09; I tried replacing the SWH09; with MN255; but that did not work either. I have been using PF1 for line 1 and PF2 for line 2 but now my KXPA100 is on the way and I want to use PF2 as a quick way to toggle between 5 watts and 100 watts. I suspect I will have the same problem when I try that macro. 73 and thanks for any help you can give. Ken W0CZ [email protected] Sent from my iPad= ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
