Thanks Wayne, We all knew that selecting the Elecraft line was the best choice we could make and you just once again, demonstrated that.
I have the same problem with 3933kc into a windom up 50'. I found that by turning off everything and then back on, the KAT500 would whirl and clatter, but would find a happy place out there on the wire. It has also happen on 20m using a Telex 7 element beam. Best regards, Jerry, W1IE -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Wayne Burdick Sent: Monday, December 30, 2013 20:17 PM To: Elecraft Reflector Subject: Re: [Elecraft] K3/KPA500/KAT500 SWR Problem We now have a senior project engineer assigned to overall K3/KPA500/KAT500 operational issues. Improvements to firmware and documentation will result, including a new manual specifically covering setup of the full K-Line. Those of you who have reported problems will be contacted to make sure we have all of the details. We may even be duplicating one or two antennas to investigate whether antenna configuration, feedline, etc., could be a contributing factor. However, in many cases the resolution involves menu settings or system installation changes, and the new manual will address them. Our goal is to make setup and operation as smooth as possible. Thanks for your patience. 73, Wayne N6KR ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
