So iPad [I can say that because I actually know you're a human being,
you hiked me a couple of miles to the In-N-Out :-)], what am I missing
here? The instructions told me to go to the P3 before the K3, and to
put the KAT500 in between the K3 and KPA500. This has worked for me
from the very beginning, not long after the Big Bang, and for ever after
... well, at least as far as we've gotten.
Full Disclosure: The computer now goes to a little boardie-thing from
Pignology that runs my PigKnob, and then to the P3. The rest is all the
same, and it all works, still.
I thought the KAT would interrupt the KPA key line when tuning, thus it
happens before the KPA on the 15-wire Elecraft Network? Oh so much to
learn.
73,
Fred K6DGW
- Northern California Contest Club
- CU in the 2014 Cal QSO Party 4-5 Oct 2014
- www.cqp.org
On 12/30/2013 6:48 PM, Jack Brindle wrote:
Computer - P3 - K3
Computer - KPA500
Computer - KAT500
Neither the KPA500 nor the KAT500 are involved in the P3/K3 serial port chain.
Jack Brindle, W6FB
Sent from my iPad
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
