On 1/6/14 at 9:32 AM, [email protected] (Wayne Burdick) wrote:
During K3/100 testing, did you try the current-drain
measurements with CONFIG:KPA3 set to PA BYP? This may be lower
than what you get with KPA3 set to PA NOR and the POWER control
set to QRP levels.
I retried the measurements changing "PA NOR" to "PA not
installed" and "PA not installed" after power cycling
(rebooting) the radio. Most numbers differed only by one in the
least significant value. [Welcome to digital measurements. :-)]
The 10 watt measurements were 40mA less than yesterday,
[email protected] vs. [email protected] but the difference isn't very
significant and may be explained by the difference in voltage.
(However, I would expect higher current with less voltage.)
Cheers - Bill, AE6JV
---------------------------------------------------------------------------
Bill Frantz |"After all, if the conventional wisdom was
working, the
408-356-8506 | rate of systems being compromised would be
going down,
www.pwpconsult.com | wouldn't it?" -- Marcus Ranum
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
