Hi Everybody,
My K2 sn 3354 lives....thank you to everyone on the reflector for
helping me debug the couple of problems I have had along the way. If I
may make a comment about Page 74 in the manual TX alignment -
I found it curious that once the RX had been set up one has to repeat
the same procedure for TX alignment. In my case when aligning the TX for
20 Meters the output power went haywire after I set C21 and C23 to their
mid point settings and started adjusting L8 and L9. To cut a long story
short I went back to the RX pre alignment stage and set C21 and C23, L8
and L9 for maximum signal strength. Then I returned to Tx Alignment
without changing the settings...the tx power was stable at 2 watts...I
then checked all of the other bands for tx power without altering the
settings from Rx and all seems to be well...i.e 2 watts on the POWER
control, 2 watts out...on the Motorola test set. So I do not intend to
carry out any TX alignment...unless someone can explain why I should.
BTW on all bands the MDS is in excess of the quoted -135DBm - assuming
the calibration on the Motorola test set is good I get readable signals
at -137 dBm.
Lastly I would just like to thank everyone at Elecraft for such a fine
kit. It has been really been a lot of fun building the K2 and I have
learned a lot along the way....thanks guys....now to start work on the
option kits....The K2 is in the shack tuned in to a contest on 40
meters...and coping very well...I wish my morse was up to it...
73
Steve G0XAR
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
