I recently had to take my K3 out of service while I waited for a new K3SYN
board. Now that it is all back together the power level on the K3 will not
toggle when the KPA500 is switched from standby to operate. "Operate" and
"Standby" appear on the K3 LCD screen but the power level doesn't change when I
switch the amp in. Everything is hooked up the way it's been for the past
three years, only the K3AUX cable, power and RF in/out are connected on the
KPA500.
KPA500 s/n 112 FW 1.33
K3 s/n 1417 FW 4.67
I know I'm just missing something simple. Thanks.
73,
Rob
NV5E
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
