A similar approach is documented here: http://forums.hrdsoftwarellc.com/showthread.php?27766-HRD-amp-P3-Macro-Progr amming-Note
- 73 de Mike, K6MKF, W6NAG, Secretary - NCDXC, IDXG, RRC #933, K3-P3-KPA500-KAT500 Addict, Maui -----Original Message----- From: elecraft-boun...@mailman.qth.net [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of mike Sent: Saturday, June 08, 2013 11:30 AM To: elecraft@mailman.qth.net Subject: Re: [Elecraft] P3 macro problem As N2BC explained to me, the programmed buttons on the K3 work directly rather than through the CAT 'stream', so the commands don't get to the P3 at all. I trieda different approach, placing the commands in a CAT macro in HRD 6. I was able only able to get it to execute when I wrapped them within an 'dummy' K3 command, that is focusing on a K3 menu item (MN053;), issuing the P3 commands and then closing the K3 menu: MN053;#FXT0;#FXT1;#FXA1;MN255; It works. -- View this message in context: http://elecraft.365791.n2.nabble.com/P3-macro-problem-tp7574907p7574912.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html