When My K3 (kit) was about a year old it developed a similar issue. In my paranoia to not damage the TMP connectors, I had not used enough force to press home the TMP located just under the right forward corner (Toward the front panel) of the sub-receiver on the main board. I actually traced the signal to that point! Now I'm a little less paranoid and make sure the TMP connectors are firmly pressed home. 73 George AI4VZ
-----Original Message----- From: Bob KD7YZ Sent: Friday, January 17, 2014 1:44 PM To: K3 List Subject: Re: [Elecraft] K3: "XMIT" produces Display "0 W" suddenly I have learned from Elecraft that this may be indicative of two blown FET's in the 10w amp stage inside the K3. gremlins abound. And all while I was away doing chores outside. Since I had the dogs with me it must have been the inside cats! -- Bob KD7YZ http://www.qrz.com/db/KD7YZ www.denstarfarm.us/LGD ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
