I've been hoping to see the port on the back of the P3 labeled sensor used for something like this.
73, kc2vmp On Jan 17, 2014, at 2:18 PM, Al Lorona <[email protected]> wrote: > Wouldn't it be cool if the P3 could display the K3's transmitted signal in > the time domain, like an oscilloscope? If this were possible then it might be > used to obtain the classic two-tone display in the ARRL Handbook or maybe > even the classic trapezoid pattern if somehow the necessary synchronization > could be achieved. > > Al Bloom is going, "Oh, no," right now. > > Al W6LX > > >>> I have been considering a "station monitor" to monitor my RF output. >>> I have a 70MHz occilliscope that I would like to place between amp & >>> feed line to various antennas. I want to make sure my CW & SSB >>> output is clean without clicks or splatter, especially at higher output. > >>> 73 Mike DeLong KD8RQE > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
