Thanks,
It's good to know how to do this for sure.
I was otherwise astonished by how closely my k2 tracked the numbers in
the manual. If memory serves, I hadn't built anything electronic in at
least 20 years.
-----Original Message-----
From: Don Wilhelm <[EMAIL PROTECTED]>
To: [EMAIL PROTECTED]; [email protected]
Sent: Sun, 20 Nov 2005 22:42:28 -0500
Subject: RE: [Elecraft] K2 5087 first breath and some ot stuff
John,
Just peak L1 and L2 in any order that you wish. Go back and forth
between
them to be certain you get them both peaked. Any interaction is
minimal, but
go back and forth a couple times just to be certain.
73,
Don W3FPR
-----Original Message-----
But I do have a question. The final Part II action is 40 Meter Band
Pass adjustment where you adjust L1 and L2 for peak signal strength.
I did it doing first L1 and then L2 and did indeed strengthen the
signal. Is there some sequence that this should be done in? Do L1
and
L2 affect each other such that this should be a more iterative
process?
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
