Phil,
Yes, "FC" means Frequency Center, which is where the passband is
centered. The "*" means it is the default (the same as your sidetone
pitch setting for CW).
You did not ask about the Width display, but it is the width of the
passband and extends half that vale on either side of FC. Those numbers
are much more accurate than the low resolution graphic on the display,
but the display gives you an idea about which part of the ballpark you
are in.
For SSB and other voice modes, the default FC is 1.5 kHz, but I would
suggest you not worry about that, but use Hi-Cut and Lo-Cut instead of
shift and width and directly define the low and high frequency edges of
the passband. You will not be able to cut much more than to 350 or 400
Hz on the low end before loosing intelligibility, but you can cut the
high end substantially and still maintain intelligibility although some
of the voice characteristics become a bit more 'pinched'.
Attempting to use Width and Shift with voice modes will require you to
reposition the Shift each time you change the Width.
73,
Don W3FPR
On 1/31/2014 1:48 PM, Phil Hystad wrote:
I have had my K3 for four years but rarely make use of the passband tuning
features. Today though I was experimenting with APF and the passband controls
and learned that I really do not know what I am doing.
In particular, the VFO B display is a mystery to me during passband tuning and APF SHIFT
tuning. For example, in passband tuning (APF not enabled), the VFO B display says FC and
then a number like 0.70 or whatever. What does "FC" mean (I can guess, but
that would not be useful) and what is this number. I scanned all the documents I have
and have not found descriptions of the content of the VFO B readout during passband
tuning. I know it has something to do with shifting the frequency of center (I think) so
maybe FC means Frequency Center. Also, there is an asterisk in the field, like: FC
*0.68. Maybe someone can interpret the meaning of that.
If I knew the definition for passband tuning for the VFO B field content I
could probably guess at the meaning of the APF enabled display which is similar
such as: APF *0.68.
I have found lots of description of passband tuning and that part of the
display showing the passband width and position but nothing describing the VFO
B contents (not covered in documentation on alternate VFO B displays either).
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
