Sorry, Change the last "passband width" to "sidetone pitch"
My thoughts an fingers got mixed up, and I am old enough to claim a
"senior moment":-)
73,
Don W3FPR
On 2/6/2014 11:21 AM, Don Wilhelm wrote:
Arnie,
Think about it this way -- take a filter width of 1500 Hz and a
sidetone pitch of 600 Hz.
If you center the passband at 600 Hz, the upper passband limit will be
at 1350 Hz, but the lower edge will be 150 Hz into the opposite
sideband (single signal reception goes "bye-bye").
The proper position if the passband is to place the lower edge at
about 100 Hz, and the upper edge will extend to 1600 Hz.
That is true for any passband that is greater than 2 times the
passband width.
73,
Don W3FPR
On 2/6/2014 10:14 AM, Arie Kleingeld PA3A wrote:
Lyle,
What are you saying here?
The DSP filtering as a second IF would do (and I quote you) a
/terrible/ job. :-)
73,
Arie PA3A
Lyle Johnson schreef op 5-2-2014 16:35:
<snip>
The "center of the passband to the nominal pitch value" only occurs
at higher pitches and/or narrower passbands.
Think about the case where you have 1.5 kHz width selected and a
pitch of 500 Hz. You defintely do NOT want the center of the filter
and the pitch to be equal,or you'd have /_terrible _/opposite
sideband suppression.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
