Dennis,
Clearly something is intermittent.
Is your KX3 an early one? If so, the power jack was not glued to the
board, and the power jack may have broken away from the solder pads. I
forget the serial number at which they started to glue the jacks to the
board.
Either open the KX3 and check the mounting of the power jack visually or
just try 'wiggling' it a bit to see if you can power it on.
In any case you will probably have to email support. If it is the power
jack and you are capable of changing it yourself, they can get a new
jack to you. Glue the new one down with epoxy, but don't let it get all
over other areas of the board.
73,
Don W3FPR
On 2/9/2014 9:28 AM, Dennis L. Haarsager wrote:
Last night I turned it on and off twice. Didn't move it a millimeter
overnight, but this morning again the KX3 won't turn on. Intermittent
problems are the worst.
Any thoughts?
Dennis, N7DH
On Sat, Feb 8, 2014 at 9:03 PM, Dennis L. Haarsager <[email protected]>wrote:
Two hours later ... tried it one more time before going to bed and this
time it came on just fine. Seems as though one of the switches is
intermittent.
I'm on the reflector's digest mode, so won't see any responses until
tomorrow. If there were such, many thanks.
Dennis, N7DH/4
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
