Similar to others I had major problems with FSK-D RTTY with the latest beta firmware this weekend on my K3 #1210.
I often found that my K3 didn't appear to recognize on the first attempt on a band that the KPA500 was even present at all and instead put out the full 100W that I normally run when not using the KPA500. I hadn't seen this reported by others. Needless to say the KPA faulted immediately on that! I never really found a repeatable sequence that would set the power. I had seen the note that power changes in TX or RX could be different so I frantically tried either after reducing power into the teens after the KPA faulted to huge overdrives. I eventually found settings on each of 10 thru 80m that were somewhere between 400 and 500w but never felt comfortable that something wasn't going to go nuts. FWIW, I normally run 500w or a bit more on RTTY with no problems at all prior to this beta. Eagerly awaiting a fix!!! 73 jim ab3cv ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
