Jim, You can't use FREQ ENT if XVn RF is set to 0, because there's a regular K3 band (160 m) that "captures" that range. You got 490 kHz when you entered 0 using FREQ ENT because that the lowest the K3 can tune on 160 m.
If you just switch to your 10-MHz transverter band, then rotate the VFO, you should be able to get to the desired frequency. Wayne N6KR On Feb 12, 2014, at 8:06 PM, Jim AB3CV <[email protected]> wrote: > Just entered 0 for frequency via buttons and 0.490.00 (MHz) showed up on VFOA > display. > > Can't go below 490. > > If I enter via buttons 1 as the frequency I get to 1.000.00 (presumably Mhz) > but still can't dial below 490. > > The 630M band will be 472-479Khz so that won't work. > > Plus I was hoping this would work from 10 to 10.5Mhz to allow for SWL > activity outside the 630M band. > > I've got the general coverage filters. > > Thanks > > jim ab3cv > > > > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/K3-10Mhz-IF-questions-with-the-latest-beta-tp7584161p7584164.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
