Greetings, Here is a little "feedback" on the new KAT-500 firmware. I installed version 1.58 last night and was using my 160m capacitance hat vertical antenna and observed what I think is strange behavior. First, I admit my 160m cap. hat vertical is not an optimal antenna. Previous versions of the firmware however, produced acceptable matches. Version 1.54 was a little better by introducing the finer step search. The version 1.58 firmware however produces worse results in my case.
The tuning passes, the clickity-clack search, is clearly different on 160m. The KAT-500 now finds no good match in auto mode. I place the KAT-500 in "manual" mode and using the utility software set previously used capacitance and inductance values. Now the KAT-500 goes sometimes into bypass mode (I have no KPA-500), drops setting values with an audible click, and some times when I checked the utility it has gone far away in capacitance and inductance values without a "clickty-clack" tuning cycle. My K3 used to be able to produce nearly full power with its super ALC method of power control. According to my Palstar PM2000A power meter, not so much anymore, as it behaves now like traditional power fold back on 160m. It appears something is interacting. I have no evidence of RF in the shack. Jim, N8OQ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html