Hi Richard, I would say you have Trace checked under View in K3 Utility, I did it once by mistake as well..
When "Trace" selected, shows detailed diagnostic trace information. Trace may significantly increase the time required to complete operations such as firmware load. Check it out 73 Robert, S57AW 2014-02-23 21:19 GMT+01:00 Richard <hb9...@bluewin.ch>: > I loaded the latest FW releases 4.83 and 1.38 into my K3 and KPA500 (I > don't own a KAT500) and everything works smoothly. > > But while the K3 (MCU, DSP1, DSP2) used to take some 7-8 minutes to load, > it now takes over 30 minutes (yes, Utility 1.13.5.9 at 38400 bps) while all > details appear on the screen, which was not the case earlier, although I > had been using 1.13.5.9 previously. > > > Anyone else noticed this? > > > 73 > Richard - HB9ANM > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html