I replaced a coax jumper when I noticed this on 10 meters with my K3. It was fine on other bands. I had purchased some physically attractive but inexpensive coax jumpers at a hamfest. I've since invested in better, as I'm testing antenna tuner firmware.
73 de Dick, K6KR -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of zabarnick . Sent: Tuesday, February 25, 2014 11:11 AM To: [email protected] Subject: [Elecraft] zeroing K3 internal tuner My K3 SWR meter no longer reads 1:1 into a 50 ohm dummy load or matched load. The lowest it will read is 1.2:1. Is there a calibration or zeroing I should redo? Steve N9SZ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
