I was only able to get U5 pin3 down to 0.03VDC during the SWR Bridge Null test. Is that low enough? The manual says 0 volts or close to it.
Jeremy VA3ZTF Don Wilhelm-4 wrote > Jeremy, > > You did not mention it, so I have to ask - when connected as you > describe, did you first obtain a good null at U5 pin 3 (by adjusting > C31)? That is a necessary first step. If you did not get a voltage > measurement in the single digit millivolt range (less than 10 > millivolts), then 'all bets are off' and you need to first resolve that > problem. -- View this message in context: http://elecraft.365791.n2.nabble.com/KAT100-Power-Calibration-Problem-tp7584832p7584864.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
