Thanks Matt - For my setup RTTY uses AFSK A, PSK uses DATA A.
The problem (red-faced) was VOX Gain was zero. 73, Mike On Mar 4, 2014, at 9:51 AM, Matt Zilmer <[email protected]> wrote: > Hi Mike, > > If you're using external sound for your data modes, you should have > the mode set to DATA A, not AFSK A. Having your audio set to Line in > DATA A mode is correct, unless you're going through the mic and phones > jacks. Most people use the line in/out for external data modes (very > handy!). > > For keying, see CONFIG:PTT-KEYT. You can use DTR or RTS to key the > K3. You can also enable VOX, but there will be a slight start up > delay before the rig enters TX (probably not enough to worry about). > > 73, > matt W6NIA > > On Tue, 4 Mar 2014 08:32:27 -0500, you wrote: > >> I started to play with RTTY this morning, and cannot get the K3 to transmit. >> >> The K3 is set for AFSK A, 2125 170. Vox is on. Monitor level is 15. CW works >> FB. >> >> The computer is a MacBook Pro pushing an iMic set for line level. I can hear >> the output from the iMic if I plug fones into it. >> >> The RTTY program is CocoaModem 2.0. >> >> What have I missed/mis set? >> >> 73, Mike NF4L >> >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html > Matt Zilmer, W6NIA > -- > "Give me six hours to chop down a tree and I will > spend the first four sharpening the axe." -A. Lincoln ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
