What is your MAIN:MIC+LIN set to? It sounds as if it may be set to ON,
so that you are getting audio input from both the microphone and the
Line In jack. In your setup, MAIN:MIC+LIN should be OFF. When the radio
is in Data mode (DATA A or AFSK A), MAIN:MIC SEL should be set to LINE
IN to select the SignaLink input and mute the microphone input. In Data
modes, the MIC control on the K3's front panel changes its function to
act as a Line In level control. Changing MAIN:MIC SEL in Data mode will
not change its setting in SSB, and the Line In level setting of the MIC
control will not affect the Mic gain setting for SSB. In SSB, MAIN:MIC
SEL will still select the correct microphone input and mute the Line In
input provided MAIN:MIC+LIN is set to OFF.
The fact that you are having audio problems with the audio and PTT
cables connected to the K3 but disconnected at the far end does suggest
that the audio cables may be acting as antennas and picking up RF. If
so, this could continue to affect your signals in DATA modes even after
you solve your issues in SSB, and you will need to solve that. There are
others who are better qualified than I am to deal with that kind of
issue, but one possibility is that you may have common-mode RF on your
feedline that is being picked up by the audio or PTT cables.
73,
Rich VE3KI
K6VWE wrote:
I am using a SignalLink USB interface to my K3 with the cables provided by
Tigertronics, and the FLDIGI software. The cables from the SignalLink are
plugged into line in, line out and PTT on the back of the K3. Things seem
to work fine in digital modes, although I have actually only tried the
combination on PSK31. When I switch to SSB, however, I am getting reports
of distorted audio, and when I monitor my audio I can hear it too. One
contact said it sounded like the opposite sideband not being suppressed
enough and slightly delayed.
I have tried the following to solve the audio problem:
1. Turning off the SignalLink when I am in SSB mode. In this case, in
addition to the above-mentioned distortion, I get an audio tone on my voice
signal which can be heard by whomever I am talking to.
2. Disconnecting the cables at the SignalLink but leaving them plugged into
line in, line out and PTT at the back of the K3 when in SSB. This does not
fix the problem.
3. Disconnecting the cables at the back of the K3 - line in, line out, PTT.
This solves the problem and I again receive reports of "great audio" as I
always have.
It seems like the above symptoms could indicate an "RF in the shack" problem
though I have not had any RF problems in the past. My K-Line (K3, P3,
KPA500) is all connected together with grounding strap, however the
SignalLink box has no grounding port, so it is not connected to the other
equipment other than with the signal and PTT cables, nor is my computer
connected to the K-Line with grounding strap since it is about five feet
away from the K-Line. My CONFIG: LIN OUT setting on the K3 is NOR 010, and
I am running the latest firmware, 4.83/2.82.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
