HND it was. I don't know how that could have happened, but it did. I
forgot about that menu option because I never use it.
Thanks for the speedy reply! It's nice to know that there are gurus
like you out there watching out for us.
Ken - N9QIL
On 3/17/2014 8:28 AM, Don Wilhelm wrote:
Ken,
Did you inadvertently change the menu INP parameter to HND?
If that is OK. try reseating the firmware to clean off any possible
oxidation on the leads and socket.
Still did not fix it? Re-solder R19, R20 and RP5.
73,
Don W3FPR
On 3/17/2014 7:54 AM, Ken Wezeman wrote:
I have used my K1 for years without a problem. Some time ago the
keyer started sending a few random dits and dahs in the middle of a
QSO for no obvious reason. I let it sit for a few days while I
thought about that and when I tried it again it worked normally. Now
it has a new problem. The left paddle sends a constant signal like
using a straight key. The right paddle seems to do nothing. I tried
the paddles on my K2 and they worked fine. I tried my K2 paddles on
the K1 and I still had the problem. So it isn't the paddles.
I have no clue as to what is happening. I hope someone else does.
Any suggestions?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
