Ed, See page 20 of the K3 manual, in the Line Out setting. You can set the Line Out level in Config, or it can be set to =PHONES, which is what it sounds like you have it set to.
73, Joe, N1QD On Thu, Mar 27, 2014 at 3:09 PM, Edward F. Steinfeld <[email protected] > wrote: > I have just connected my SignaLink to the K3 using SignaLink supplied K3 > cables. I find the Line Out amplitude varies according to where I have the > AF control set. I would have thought that Line Out was a constant signal > level. Without setting the AF level quite high I do not get good PSK > reception. At those levels it is too loud for my ham shack (and my wife). > What I have I set wrong? > > Ed -- KB1ZJK > > Edward F. Steinfeld > 25 Arbor Glen Drive > Stow, MA 01775-1258 > Home: (978)897-3127 > Cell: (978)376-3146 > mailto::[email protected] > http://www.go-embedded.com <http://www.go-embedded.com/> > http://en.wikipedia.org/wiki/Mount_Steinfeld > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > -- Joe Harris, N1QD ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
