Gernot,
See the KXBC3 manual page 4.
For the BAT ERR message it reads:
"Battery missing or battery voltage out of range due to a fully charged
pack or a defective or
missing cell. With the KX3 on, tap any switch to clear the message. The
charging cycle is
terminated (does not restart automatically when the condition is
corrected)."
That is done to prevent an attempt to charge a completely discharged or
defective battery pack.
You may have batteries that are sufficiently discharged to cause that
error, or you may have a bad cell in your battery pack. Remove the
batteries and check each one with a voltmeter. If you find one dead,
replace it, but if they are all equally low you may have to use an
external battery charger to increase the voltage a bit before charging
in the KX3.
73,
Don W3FPR
On 4/2/2014 3:50 PM, [email protected] wrote:
I get an "bat Err" message if I want to charge my battery pack on the
KX3.
The battery (NiMh) seems to be very low, as the KX3 doesn't start with
them. The LEDs light up shortly then nothing.
But if powered externally, I'd expect I get my battery recharged.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
