Yes, I have seen the user-modified P3 units. I am still hoping Elecraft will offer a set of panels to repackage the P3 into a shallow case, similar to the PX3.
73 Bruce N1RX _____ From: Jeff Stai [mailto:[email protected]] Sent: Saturday, April 05, 2014 8:05 PM To: Bruce Beford Cc: [email protected] Subject: Re: [Elecraft] PX3 case for P3? Hi Bruce. I was looking at the PX3 case today. It's not very deep and the current P3 won't fit in there. And Eric did confirm that. Some people have cut the stock P3 sides, top and bottom shorter to achieve a similar profile. 73 jeff wk6i On Saturday, April 5, 2014, Bruce Beford <[email protected]> wrote: Please consider the possibility of offering an enclosure option for the P3. In many cases, it would be nice to have the P3 in a case footprint similar to the PX3. Perhaps with the sheet metal design work already done for the PX3, this would not be cost prohibitive. Possible? 73, Bruce N1RX ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] <javascript:;> This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] <javascript:;> -- Jeff Stai ~ [email protected] Twisted Oak Winery ~ http://www.twistedoak.com/ Facebook ~ http://www.facebook.com/twistedoak ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
