Brian - The IC command will return the status of the "TEST" setting. In the first byte, bit 5 will be 0 if normal, A if in test. See page 13 of the K3 & KX3 Programmers Reference.
73, Mike NF4L On Apr 9, 2014, at 8:43 AM, Brian Alsop <[email protected]> wrote: > I'm using the K3 for measurements and want it to be in the TX TEST mode. > > The software uses SWH18. However, it is a toggle. So if "*hit" happens and > you have to run the data collection software again, it returns the K3 to the > normal mode. > > I've scanned the manual looking for a command which does the same but is not > a toggle. NADA. > > Any workarounds? > > 73 de Brian/K3KO > > > > ----- > No virus found in this message. > Checked by AVG - www.avg.com > Version: 2012.0.2247 / Virus Database: 3722/6813 - Release Date: 04/07/14 > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
