It be on page 147 in my book. Figure 9.17 shows a complete K3-->KPA500-->KAT500 setup. This is exactly how I've got mine set up. Nothing in the index, but it is in the TOC in the front. :-)
Jim / W6JHB On Wednesday, Apr 9, 2014, at Wednesday, 9:25 PM, Phil Wheeler wrote: > Surprising, because I couldn't find any mention of the KPA500 in his K3 book > by searching the pdf version. Maybe I did a typo. > > 73, Phil W7OX > > On 4/9/14, 8:55 PM, Phil Hystad wrote: >> Jim, >> >> I think you mentioned the Cady KX3 book to me on a previous similar message. >> If not, it was someone else. But, at that time, I searched for the diagram >> and could not find it. Upon the message below I searched again, page by >> page. Finally found it. Now, I looked in the table-of-contents but for >> some strange reason I never saw that section on the KX3 and KPA500. >> >> I do have a Diamond CX-210 two-position switch. I have a bunch of those in >> my shack, also one 3 position. >> >> 73, phil, K7PEH >> >> >> On Apr 9, 2014, at 7:29 PM, Jim Bennett <w6...@mac.com> wrote: >> >>> phil, >>> >>> I'm doing exactly that - I have a KX3 and a K3 that share a KPA500, KAT500, >>> and several antennas. I went by the diagram in Fred Cady's book on the KX3. >>> Works like a charm. I can get up to 250 watts out with the KX3 driving the >>> amp at 12 watts. And, no, I do not disconnect anything when I want to use >>> the KX3 with the amp and tuner. Just make sure that (1) the K3 is powered >>> off if you are using the KX3, and (2) your coax switch connecting the two >>> radios to the amp has very good isolation. I'm using a two position Daiwa >>> coax switch at the moment. >>> >>> Let me know if you need more info. I've been using this configuration for a >>> few months now. >>> >>> Jim / W6JHB >>> >>> >>> On Wednesday, Apr 9, 2014, at Wednesday, 4:23 PM, Phil Hystad wrote: >>> >>>> I am planning on configuring my KX3 to use the KPA500 and the KAT500. Has >>>> anyone done this and what did you need to do? I already know how to hook >>>> up the KX3 to the KPA500 but would like to hear from someone using all >>>> three together. In particular, connections between KPA500 and KAT500. >>>> >>>> Also, follow up question -- if you have a configuration where you switch >>>> KX3 and K3 driving the KPA500+KAT500 do you disconnect any K3 involved AUX >>>> cables? I presume you would run with the K3 powered off if you are >>>> driving with a KX3. >>>> >>>> Thanks, >>>> >>>> 73, phil, K7PEH > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
