I just made my first contact on my new KX1 with a VK5 about 700 miles away who was running a K3 -- the KX1 is indeed a very nice rig.
Initially I was getting about 2.7 W out on 40m and 3.2W out on 20m (13.8V supply, 50 ohm dummy load). I read in the manual that the output on 20m should normally be less that on 40m, and this can be achieved by compressing turns on the L2 inductor to adjust the LPF. I found that compressing turns on L2 reduced the output power on both bands, but 20m was still more output than 40m. By compressing the turns on the L1 inductor as well, 40m is now around 1.9W, and 20m is around 1.8W, so overall power is reduced, but the 20m output is now below the 40m output. In the KXB3080 module kit which I haven't built yet, I think there are some resistors that can be swapped in for R11 and R30 to bring output power back up a bit. Is there anything else I can check to make sure the LPF is set up properly? 73, Matt VK2RQ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
