Try doing the Parameter Initialization (see Troubleshooting section of
P3 Owner's Manual.) Basically you hold the LABELS key while turning on
the power with the POWER key.
Alan N1AL
On 04/10/2014 07:27 AM, George Dubovsky wrote:
OK, I just spent 2 hours as W1AW/4 on 40 cw and everything was working
fine. I changed bands and the P3 displayed:
****FATAL ERROR****
In: ddc_set_coef()
span=0
Press any active key to escape
But all keys are dead, so no escape from the black screen of death. Power
down/up does no change the message. Does anyone know what I'm up against
here? Oh, this P3 has the SVGA board installed which I am not using.
73,
geo - n4ua
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
