Ever since the most recent KAT500/KPA500 firmware updates, switching between
antenna 1 and 2 shows funny behavior.
For example, on the 20 meter band I have two antennas:
Antenna #1 -- Wire 80-meter Dipole (ladder line fed)
Antenna #2 -- Hex beam
So, I am positioned on antenna #2 for 20 meters. I switch manually with the
KAT500 to antenna #1. This works fine. Then, when I switch from #1 back to
#2, the KAT500 briefly goes to #2 enough to light up the #2 LED but then
immediately bounces back to #1. Now, if I switch again from #1 to #2, there is
no bounce back and everything is fine.
This problem is totally repeatable. Always on a bounce the first attempt to
return to #2 from #1 but the second time (done immediately) works fine without
problems.
Anyone else see this behavior.
73, phil, K7PEH
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
