Don, do you know about what the serial number was when the encoder
changed?
Thanks.
On Thu, 17 Apr 2014, Don Wilhelm wrote:
For those owners of newer K2s, be aware that the NEW K2 encoder (those with a
board soldered to the back of the encoder) has a larger shaft diameter than
the older K2 encoders.
I mention this as a way of warning newer K2 owners that the normal "K2" knob
may not fit your K2.
The new encoder shaft diameter is the same as the K3 encoders, but the K3 VFO
A knob is too large for the K2 and the K3 VFO B knob may be too small in
diameter.
Know what you have in your K2 before ordering a replacement knob.
73,
Don W3FPR
On 4/17/2014 4:53 PM, Dick, K2ZR wrote:
Review the link: http://www.73cnc.com/product_p/k2blkmain.htm
These folks make a great weighted knob for the K2. You can often pick it up
at hamfest where they are in the flea market. They generally offer a show
special for less. My guess is they will be at Dayton since trhey are
located
in Ohio.
I've been a happy user.
73,
Dick, K2ZR/4
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
--
Hisashi T Fujinaka - [email protected]
BSEE(6/86) + BSChem(3/95) + BAEnglish(8/95) + MSCS(8/03) + $2.50 = latte
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
